TackleTour

I did a gear swap this summer. My 71MGL became buzzy after about three trips, so I ordered and installed the regular 71 gears. Fished the reel a few times and it is still very smooth. Not a fan of micro gears. That is suck. I’m not even sure if I want to spend 30 bucks for new gear and know it is g...

Thanks will do that. I was afraid the new same gear will get buzzing again, why I tried MM gear.

Lol, yeah I know, it is just I used to call them all 70 series. I owned both 70 and 71.

My Curado 71 gets very geary feel so I decide to get new gear set. I assumed the 71 K MGL gear set would fit regular 70 from using the same frame. Apparently it is not, The mgl MM gear fit perfectly but seem to have more resistance when reeling. I can’t imagine what cause them to not be swap able. B...

Bantam1, sorry I tried to look but can't find any shrim. The only part I see that can be move and might help is washer bnt5353(I use curado 70 schematic)

I was able to finally source a set of Engetsu 101hg gears and confirmed that they fit, along with the drag clicker. The following are the parts needed to swap into a Curado 71hg: no36 washer no37 washer no38 pin no39 spring no40 spring holder no124 drive gear no127 pinion gear Turning the handle is...

Oh no, I got SLX and hope to switch bearing on those mainshaft and pinion gear support.

My scorpion 70 got a palm side plate that is not tight fit. It locks no problem but it can move in and out a little. Anyone has this problem on Scorpion 70? I tried fitting with my curado 70, it seem the frame is the problem becuz curado side plate not tight fit as well.