MB Zonda Hedgehog BFS spool corrosion
- Carlos Carrapiço
- Platinum Angler
- Posts: 1088
- Joined: Mon Feb 28, 2011 3:22 am
MB Zonda Hedgehog BFS spool corrosion
I have the above mentioned reel and I have been saltwater fishing with it. Recently I notice some corrosion (pitting) in the spool rim.
Is the spool body aluminum or magnesium?
Any solution to stop the corrosion spread?
Thanks
Is the spool body aluminum or magnesium?
Any solution to stop the corrosion spread?
Thanks
-
- TT Moderator
- Posts: 6801
- Joined: Mon Feb 28, 2011 1:56 pm
- Location: Oxford GA
Re: MB Zonda Hedgehog BFS spool corrosion
It is aluminum. Bead blast and clear epoxy in the pitted area is all you can do. Aluminum isnt salt-proof, only resistant. Bare aluminum will pit readily if exposed continuously to salt. Sounds like the anodizing might have been compromised.
Try not to let your mind wander. It is much too small to be outside unsupervised.
-
- Elite Angler
- Posts: 420
- Joined: Tue Jul 01, 2014 12:28 am
Re: MB Zonda Hedgehog BFS spool corrosion
All you can really do to prevent future issues, is remove spool and clean rim and frame carefully after each use, i think.Carlos Carrapiço wrote: ↑Wed Dec 09, 2020 3:44 pmI have the above mentioned reel and I have been saltwater fishing with it. Recently I notice some corrosion (pitting) in the spool rim.
Is the spool body aluminum or magnesium?
Any solution to stop the corrosion spread?
Thanks
- Carlos Carrapiço
- Platinum Angler
- Posts: 1088
- Joined: Mon Feb 28, 2011 3:22 am
Re: MB Zonda Hedgehog BFS spool corrosion
Thanks for the replies.
For the time being I have clean it and oiled with a bit of lithium oil hopping to stop the corrosion.
Guess the saltwater adventure has ended for this spool.
For the time being I have clean it and oiled with a bit of lithium oil hopping to stop the corrosion.
Guess the saltwater adventure has ended for this spool.
Re: MB Zonda Hedgehog BFS spool corrosion
You can get a Bonderite pen and coat the exposed aluminum.
- Carlos Carrapiço
- Platinum Angler
- Posts: 1088
- Joined: Mon Feb 28, 2011 3:22 am