HI i just purchased a 90mm bassart handlle , the handlle was the easy part , i am trying to put the orginal knobs on the new handle. when i tighten the screw down the knobs turn , when leave in loose it unscrews it self , does anyone have a diagram of it, many i'm not using all the parts? please help..
to fasten old knobs on new handle ,
first inside bearing
sec. the knob spacer
third knob
fourth outside bearing
fifth washer
sixth new screw
is this correct??
thansk you bruce
100dc / bassart handles
- Kingofpool12
- Senior Angler
- Posts: 96
- Joined: Tue Aug 22, 2006 5:36 pm
- Location: Iowa
Re: 100dc / bassart handles
Its sounds like your using to many knob spacers.
Try this....
1. Knob spacer
2. bearing
3. knob
4. bearing
5. handle screw
Hope this helps ya
Try this....
1. Knob spacer
2. bearing
3. knob
4. bearing
5. handle screw
Hope this helps ya
Re: 100dc / bassart handles
I suspect KingofPool has it. However, some knobs may require both a spacer and a washer (or 2 washers), to eliminate any lateral slop in the knob. In this case, put both below the bottom bearing. In any case, you don't want a washer on top (beneath the screw), because the screw will back out.
Chuck
Chuck
TackleTour
Contributing Editor, Gear Crew Member and Moderator
Contributing Editor, Gear Crew Member and Moderator
Re: 100dc / bassart handles
Cool, and to think I biuld biuldings for a living
Re: 100dc / bassart handles
It could be worse, you could be a spelling teacher. j/k having fun with ya. G