Long-time reader here. HAve learned a ton over the years.
I ran into an issue with a kick lever on a discontinued Quantum PR600CX. Kick lever has a gouge or groove where it contacts the trip ratchet cog gear. So the kick lever skips on the trip ratchet but doesn't engage reel from freespool.
I have called all over the country looking for a replacement part, but nobody has one. I'm down to trying to repair it. I believe the kick lever is pot metal so I don't know if it can be welded to build up that small area. I know pot metal is difficult to impossible to weld. I have my doubts that something like JB Weld would hold up. Any suggestions?
Repair a kick lever?
Re: Repair a kick lever?
Silver solder might stand up, Just get it hot enough to melt the solder. I would say brazing might also work.
Or get friendly with a machinist.
Or get friendly with a machinist.
Re: Repair a kick lever?
Thanks for the suggestions. Going to talk to a welding shop at lunch. Will see what they say.
Re: Repair a kick lever?
Welding shop said they couldn't do anything with it.