Page 1 of 1
Coastal TWS drag upgrade
Posted: Sat Jul 27, 2019 4:05 pm
by jjbassnforfun
A bud has been beating up his coastal's drag with strippers and blues. Asked me about beefing it up some. Anybody got a Z200 that can measure the OD of the steel washers?
Looking for eared washers 32mm in diameter to be more specific?
Re: Coastal TWS drag upgrade
Posted: Wed Jul 31, 2019 12:38 pm
by Fishing4Fun
Any one that beats up their drag with strippers, in for a world of hurt
Re: Coastal TWS drag upgrade
Posted: Wed Aug 14, 2019 7:33 am
by jjbassnforfun
Ordered some of the Z200 metal washers. Machined the drive gear to except the eared washer and wahla stacked drag in a coastal, zln tw or Zln sv tw. Should also work on the 2ng gen Fuego and tatula's
- 0726190846-00.jpg (54.07 KiB) Viewed 4091 times
Re: Coastal TWS drag upgrade
Posted: Wed Aug 14, 2019 7:41 am
by MountainMan 83
jjbassnforfun wrote: ↑Wed Aug 14, 2019 7:33 am
Ordered some of the Z200 metal washers. Machined the drive gear to except the eared washer and wahla stacked drag in a coastal, zln tw or Zln sv tw. Should also work on the 2ng gen Fuego and tatula's
0726190846-00.jpg
Very nice project. I have a Coastal and access to a mill. Might have to give this a go.
Re: Coastal TWS drag upgrade
Posted: Wed Aug 14, 2019 7:51 am
by jjbassnforfun
I also used a Shimano BNT4292 to top off the stack, So the stock collar could be used.