Handle knob problems
Posted: Tue Oct 22, 2019 12:00 am
I have a Daiwa Japan SS SV103 baitcaster. I've had it for a couple years now and done a lot of cranking with it. Only problem I ever had with it was the short handle. So I finally ordered a longer carbon fiber handle from the spool high speed bearings website since I was already ordering new spool bearings for it from there. I put the new handle on and put the stock Daiwa knobs on the new handle and when I tighten the little screws all the way down the knobs won't even turn. I loosened the screws just enough for the knobs to turn. I went fishing and within 10-20 minutes of cranking one of the knobs had came loose to the point it was about to fall off. I noticed every time the knob turns backwards it's loosening the little screws. I noticed when I took the screws out they had a little blue loc-tite on them so should I use more loc-tite and tighten them down and loosen them so the knobs turn and then the loc-tite will keep them tight or am I doing something else wrong? This is the first time I've ever taken knobs off so any help would be appreciated. Thanks.