Page 2 of 2
Re: Source for Pinion/Drive Bearings
Posted: Sat Jan 20, 2024 8:43 pm
by HellaBread
Id rather get bearings made by a reputable company (nsk, koyo, NMB), NMB minebea being the benchmark to beat for a cheap reliable high quality bearing (they don’t supply over 50% of the worlds bearings by being bad) but to each their own. Also they’re not even that expensive from shimano, the average is $2-$5 a pop, the only ones that stand out are the parts numbers that use NSK casstops which are justifiably priced due to the extra high corrosion resistant properties of the material used (TBN-6H).
Re: Source for Pinion/Drive Bearings
Posted: Sat Jan 20, 2024 8:46 pm
by HellaBread
one of these days if i have the energy and time i’ll make a giant cross reference spread sheet of all daiwa/shimano parts numbers for bearings sizes, what company they’re made by, and any additional notes about said specific bearing.
Re: Source for Pinion/Drive Bearings
Posted: Sun Jan 21, 2024 5:23 am
by dragon1
HellaBread wrote: ↑Sat Jan 20, 2024 8:46 pm
one of these days if i have the energy and time i’ll make a giant cross reference spread sheet of all daiwa/shimano parts numbers for bearings sizes, what company they’re made by, and any additional notes about said specific bearing.
A lot of that information was on the Daiwa Tuning Data Repository but TT crashed a few times and the data is long gonzo.