Molix Lover Spinnerbait
-
- Pro Angler
- Posts: 1948
- Joined: Sat Aug 29, 2015 1:34 pm
- Location: NW OKC OK USA
Molix Lover Spinnerbait
I was skeptical, but I got one anyway since it's been spinnerbait weather lately. I can't seem to keep the center blade turning. Half the time it gets sort of wrapped around the arm and just sits there, causing the bait to run off to the side. I think it would be a killer bait if it worked right. Did I just get a dud? Anyine have any suggestions? I want to like this one.
This is the way.
Re: Molix Lover Spinnerbait
I have a few of these and haven't had a problem with that center blade. It does crash into the blades on the sides every now and then causing the bait to foul momentarily, but then it usually snaps back into place and works just fine. The momentary, intermittent fouling is actually a good thing.
Cal, Managing Editor
"fish with mindfulness : beware the darkside"
"fish with mindfulness : beware the darkside"
-
- Pro Angler
- Posts: 1948
- Joined: Sat Aug 29, 2015 1:34 pm
- Location: NW OKC OK USA
Re: Molix Lover Spinnerbait
Thanks, Cal. I think i just need to spend more time with it.
This is the way.
Re: Molix Lover Spinnerbait
It could be a bad swivel that is not turning that is causing the problem.poisonokie wrote:Thanks, Cal. I think i just need to spend more time with it.
-
- Pro Angler
- Posts: 1948
- Joined: Sat Aug 29, 2015 1:34 pm
- Location: NW OKC OK USA
Re: Molix Lover Spinnerbait
That's a good point. It seems to work, but I'll swap it anyway. I think I just need take more care when casting it honestly. A lot of times I think it's getting wrapped around the line/wire mid cast or on touchdown.
This is the way.