Page 1 of 1
Snaps
Posted: Thu Jan 30, 2020 5:54 am
by hotdogin
Due to low line capacity of BFS spools I was wondering if using a snap would be a good idea in order to save some line. Would it greatly alter or kill the action of small lures like a Pins minnow or even a MB Baby Griffon? If not then what size is recommended?
Re: Snaps
Posted: Thu Jan 30, 2020 8:20 am
by Hobie-Wan Kenobi
Try looking into the Cultiva Tairiki Snap size 000. They are TINY and do not hinder the action of lures like other snaps do
Re: Snaps
Posted: Thu Jan 30, 2020 8:37 am
by BRONZEBACK32
Braid to leader is another option.
Re: Snaps
Posted: Thu Jan 30, 2020 8:51 am
by dennis_rf
Correctly sized snaps rather enhance the lure action as the lure can move around freely. For the same reason hard lures come with split rings to tie on right? If you swap out the split ring and rather use a snap you’re just saving line and time.
000 can turn out super small, 00 is the smallest I usually go.
AND 8-braid to leader to I crease casting distance.
Honestly, I don’t get why tying on directly would be a benefit (ok maybe for punching but you don’t do that with bfs gear). Here in Germany we always use them, over in America they seem super uncommon. Why tho?
Re: Snaps
Posted: Thu Jan 30, 2020 9:22 am
by hotdogin
Thanks for the info and recommendations. I understand the purpose of split rings allowing for more freedom, but wasn't sure if the shape, size, and added weight of a snap would hinder an already lightweight lure.
For general bass fishing I was always somewhat discouraged from using snaps because of the added bulk. I was under the impression that the less hardware at the end of the line was better for a more natural look.
Re: Snaps
Posted: Thu Jan 30, 2020 10:37 am
by Hobie-Wan Kenobi
hotdogin wrote: ↑Thu Jan 30, 2020 9:22 am
Thanks for the info and recommendations. I understand the purpose of split rings allowing for more freedom, but wasn't sure if the shape, size, and added weight of a snap would hinder an already lightweight lure.
For general bass fishing I was always somewhat discouraged from using snaps because of the added bulk. I was under the impression that the less hardware at the end of the line was better for a more natural look.
I should add that I usually take the split ring off if using snaps for tiny cranks. Much better action
Re: Snaps
Posted: Thu Jan 30, 2020 11:27 am
by Dalleinf
Hobie-Wan Kenobi wrote: ↑Thu Jan 30, 2020 10:37 am
hotdogin wrote: ↑Thu Jan 30, 2020 9:22 am
Thanks for the info and recommendations. I understand the purpose of split rings allowing for more freedom, but wasn't sure if the shape, size, and added weight of a snap would hinder an already lightweight lure.
For general bass fishing I was always somewhat discouraged from using snaps because of the added bulk. I was under the impression that the less hardware at the end of the line was better for a more natural look.
I should add that I usually take the split ring off if using snaps for tiny cranks. Much better action
X2
I typically remove split rings and use a snap or less often attach a solid ring to the split ring if not using a snap. I am not too happy with thin line (esp braid) rubbing against the edge of a split ring.
Re: Snaps
Posted: Thu Jan 30, 2020 2:25 pm
by uljersey
Dalleinf wrote: ↑Thu Jan 30, 2020 11:27 am
Hobie-Wan Kenobi wrote: ↑Thu Jan 30, 2020 10:37 am
hotdogin wrote: ↑Thu Jan 30, 2020 9:22 am
Thanks for the info and recommendations. I understand the purpose of split rings allowing for more freedom, but wasn't sure if the shape, size, and added weight of a snap would hinder an already lightweight lure.
For general bass fishing I was always somewhat discouraged from using snaps because of the added bulk. I was under the impression that the less hardware at the end of the line was better for a more natural look.
I should add that I usually take the split ring off if using snaps for tiny cranks. Much better action
X2
I typically remove split rings and use a snap or less often attach a solid ring to the split ring if not using a snap. I am not too happy with thin line (esp braid) rubbing against the edge of a split ring.
I feel the same way. Maybe it's a confidence thing, but I think the knot is much more durable when tied around the single round diameter of a wire snap. I use them on virtually all hard baits, not just the ultra light ones.
Re: Snaps
Posted: Thu Jan 30, 2020 5:48 pm
by fishes
I just started using snaps on my moving bait setup. Not to save line but out of laziness basically. That said, I do notice Im going through less line (using an Aldebaran bfs)
Re: Snaps
Posted: Thu Jan 30, 2020 8:12 pm
by Sore Thumb
Dalleinf wrote: ↑Thu Jan 30, 2020 11:27 am
Hobie-Wan Kenobi wrote: ↑Thu Jan 30, 2020 10:37 am
hotdogin wrote: ↑Thu Jan 30, 2020 9:22 am
Thanks for the info and recommendations. I understand the purpose of split rings allowing for more freedom, but wasn't sure if the shape, size, and added weight of a snap would hinder an already lightweight lure.
For general bass fishing I was always somewhat discouraged from using snaps because of the added bulk. I was under the impression that the less hardware at the end of the line was better for a more natural look.
I should add that I usually take the split ring off if using snaps for tiny cranks. Much better action
I typically remove split rings and use a snap or less often attach a solid ring to the split ring if not using a snap. I am not too happy with thin line (esp braid) rubbing against the edge of a split ring.
You an get oval shaped split rings which pretty much eliminate knots migrating around the ring. Mustad make them and Daiwa used them on the small Woofer vibes.
Re: Snaps
Posted: Thu Jan 30, 2020 8:36 pm
by Dalleinf
I have many of those oval and egg/triangle shaped split rings -also from DUO I believe. Yes, they are better for direct ties or at least they make me worry less :-)
Re: Snaps
Posted: Mon Feb 03, 2020 10:13 am
by Allsorts
I've had some bad experiences with snaps - I've recently started using Mustad Fastach clips in the smallest size and pulled hard on them and so far so good. With my deteriorating eyesight and clumsiness, I find lure changes super easy with it as long as lure eye isn't obstructed (like with poppers). For river fishing (spinners, plugs and SPs), I won't use anything else. They aren't any good for super small lures (<1.5")which I don't often use anyway.