I am wondering if anyone can help me out here.I have a seeker bs706s I built for a friend,and he snapped it between the split grip.I need a piece of blank I can epoxy in-and just extend the handle from the break down,and use a full cork handle.I usually have pieces around from shortened blanks,but I dont have any that are that big in diameter right now.blank measure 18.64mm outside diameter at the break,and I need a piece between 6-8 inches long.Does anyone have any scraps from a large diameter build that they shortened?
Thanks in advance if you read down this far!
fshn4lmt(Matt Mahle)
Sunbury,Oh
fellow builder help.
Re: fellow builder help.
Sorry I don't have any that would fit. I have butt sections from that blank but no pieces from that part of the blank. You could email Seeker and ask them, or worse case you could buy another blank to cannibalize for the section you need.
Good luck.
Stan
ShakedownRods.com
Good luck.
Stan
ShakedownRods.com
- Mattman
- TT Gear Crew
- Posts: 2914
- Joined: Sun Apr 24, 2005 5:26 am
- Location: Fergus Falls, MN - Otterods - Hand Crafted High Performance Fishing Rods
- Contact:
Re: fellow builder help.
Aluminum tube is an option.
Woven carbon tube is an option.
I will also use rod blank that isn't quite large enought.
In any of those instances I may need to fir them out. Mesh drywall tape. Wrapped D thread. Full length Flex Coat arbors. Methods like that.
Woven carbon tube is an option.
I will also use rod blank that isn't quite large enought.
In any of those instances I may need to fir them out. Mesh drywall tape. Wrapped D thread. Full length Flex Coat arbors. Methods like that.