I was working with the blank designer at Mudhole comparing some blanks using their two position rod support and measuring chart. He used a short length of the smallest size tubing for holding guides coupled with a 3D printed ring to slide over the blank tip for attaching weights.
I made something similar from the tubing and a small eyehook. A small cable tie holds the eyehook in the tubing. Out of about 60 blanks measured, I had one slip; it was a size 4.0 tip extra-fast painted blank. A second small cable tie held it tight.
The picture is a 3 power MB blank with 20 oz attached. This makes my measuring process a lot quicker.
RDA Weight Attachment
RDA Weight Attachment
- Attachments
-
- MB783_1_20oz_Detail.jpg (50.61 KiB) Viewed 2890 times