i had a couple of unsanded blanks around, but i cant seem to find them at the moment.
I’m not going to say emphatically that it’s not because I didn’t ask the designer who was present how they came about the texture.
But if it; it is most definitely different then any cellophane warp I have seen. The un-sanded and partially sanded blanks I have are nothing like this. On the others here the ridges are smooth from ridge to ridge more like high spots. These are very distinct and angled like the teeth on a bastard file edges that could be used to file in one direction, if it were metal.
That is my one BIG concern about this blank that if the line were to rub the blank during casting or while fighting a fish.
These edges are sharp enough to damage the line
I think Vince might be right about them being laser cut into the rod, it could be for structural integrity or like the blanks Cuke referred to; a cosmetic thing to distinguish their blanks from others.
This finish is however different from the ones on the home page no blue and a textured different pattern (not smooth)
it could be cosmetic, but why? doing that groove every 1mm over the length is very time consuming... for a poor result (sharp corners and makes it look like it is a raw blank!). Wrapping threads will be a challenge as well
I still think the texture is the result of whatever they used to wrap the rod during curing. Might not be cellophane that we are used to seeing...
does the diameter vary of the blank? The outside diameter looks very wavy in the pics
regardless of the finish, have you been able to flex and measure the rod power? how does it compare to other "heavy" power rods? The light weight is very impressive, if it does have the rated power
- TT Gear Crew
- Posts: 2832
- Joined: Sun Apr 24, 2005 5:26 am
- Location: Fergus Falls, MN - Otterods - Hand Crafted High Performance Fishing Rods
Exactly.jimmyb wrote: The light weight is very impressive, if it does have the rated power
The listed power rating can be deceiving. There is a popular blank in a Mag Bass taper that gets raves for how light it is. "Lightest Heavy power blank you can buy" When I measured the blank it came out to be 2 powers lighter than what its listed lure rating would indicate. And, in the end, heavier than comparable blanks.
Anxious to hear some results.
Otterods-High performance fishing rods
Yes and no!
Most of what you are seeing in waviness is a lighting optical allusion.
It is wavy where the extra matrix material was added but not the rest of the blank
The matrix stuff starts at 11-3/4” up from butt and stops at 34-1/2” probably affecting the stripper guide, but not the rest.
I have been looking/studying this under different magnifications to better understand and explain it.
If you have the ability to download to your computer's pictures file and can magnify it many times. Look at the bottom section of the last picture you can see that was appears to be the cut section actually looks like raised seams, as if they are the overlap edges and that the material between seams is concaved.
So here is the kicker
After looking at it magnified many times I’ve also noticed a seam that runs tip to butt like a glue joint, (except for the section where the matrix pattern is, which looks like an over sleeve)I will send you a picture of it to look at and post if you don’t mind.
This whole thing may be some type of cosmetic treatment applied after the blank was made and sanded.
Don’t know, definitely something I’ve never seen on any other blank
If you can magnify the picture I’m sending you? You will definitely see the seam, especially along the left side where it almost looks like it separated a bit during construction
Not run any numbers on it but can tell you the action is real close to my SCV 7’6” MHMF, with a bit more power.
Should be a good pitching rod but not what I would suggest for heavy flipping stick