Super Tuning - Pinion and Yoke - Calcutta 200GTB
Posted: Wed Mar 27, 2013 5:40 am
Ok,
So over the winter I pulled apart my Calcutta 200GTB for some maintenance and upgrades. Replaced spool bearings with boca’s and carbon drag washers. Then I start reading up on super tuning. So I polished the shims, the spool shaft, inside the pinion gear and brake race way. Anyway I noticed one part that in my mind could be polished but thought I would ask around first. It’s the outside of the pinion gear. The part that comes in contact with the yoke right in the center. When I looked at it closely I noticed it is rough I can actually see lines from when they cut out the teeth for the gear portion on the pinion.
My question is, if I polish that down smooth will it cause any problems?
So over the winter I pulled apart my Calcutta 200GTB for some maintenance and upgrades. Replaced spool bearings with boca’s and carbon drag washers. Then I start reading up on super tuning. So I polished the shims, the spool shaft, inside the pinion gear and brake race way. Anyway I noticed one part that in my mind could be polished but thought I would ask around first. It’s the outside of the pinion gear. The part that comes in contact with the yoke right in the center. When I looked at it closely I noticed it is rough I can actually see lines from when they cut out the teeth for the gear portion on the pinion.
My question is, if I polish that down smooth will it cause any problems?