curado 201e7/chronarch 201e7

[wheelsreelsrods]

first time posting here!
noob question its this two reel take the same drive gear&pinion gear?
long story short...messed up a new brand reel so I need to source a set...
thank you

[ss30378]

Yes they are the same

[wheelsreelsrods]

Yes they are the same

Thx,
A retailer said no…

[Bantam1]

The gears and internal parts are the same. Only appearance parts are different because of the colors, aside from that they will interchange.

[wheelsreelsrods]

I really need some help now, after putting everything back together(10x) the reel is sooo rough when I turn the handle it’s feel like the drive gear and pinion gear are not align. It got worst when the drag is on max, at this point this noob don’t know what to do pls help..

[Bantam1]

It sounds like you do not have the drive gear down all of the way. Make sure the ratchet is seated correctly on the drive shaft. Then push the gear down all of the way. Also I assume you did use our ACE 2 grease on the drive gear.

[wheelsreelsrods]

That’s what I thought, but I push down hard til it snap in, yes I used shimano grease.
At this point I don’t know what to, I wish this forum have a “how to” video might make things easier and save a few bucks. Thank you for your time

[DirtyD64]

That’s what I thought, but I push down hard til it snap in, yes I used shimano grease.
At this point I don’t know what to, I wish this forum have a “how to” video might make things easier and save a few bucks. Thank you for your time

Try it all again, might be one of those ghost issues. Had this happen to me on a reel and it was line caught in the spool area. A small piece of cut line, debris, not the actual casting line. Just sometimes have to go back and run it again. I would make sure all the gears for sure are what they are supposed to be, normally all ratios should interchange similarly but I wasn't into fishing big when this reel was out.

[wheelsreelsrods]

That’s what I thought, but I push down hard til it snap in, yes I used shimano grease.
At this point I don’t know what to, I wish this forum have a “how to” video might make things easier and save a few bucks. Thank you for your time

Try it all again, might be one of those ghost issues. Had this happen to me on a reel and it was line caught in the spool area. A small piece of cut line, debris, not the actual casting line. Just sometimes have to go back and run it again. I would make sure all the gears for sure are what they are supposed to be, normally all ratios should interchange similarly but I wasn't into fishing big when this reel was out.

Can you take a look at the following short clip this is what I’m dealing with, and tell me what you think/know https://youtube.com/shorts/XzMu7M6hILU?feature=share

[wheelsreelsrods]

Problem solved!
It’s was the “pawl” took me a lot of hrs but I figured it out