Minkotta Max 80- RUST issues
-
- Platinum Angler
- Posts: 812
- Joined: Sun Jan 15, 2012 6:08 am
- Location: Denver, CO
Minkotta Max 80- RUST issues
My trolling motor is starting to rust where the what meets the head unit. Please advise....
My plan was to sand it down and spray it with something marine grade. What can I do?
My plan was to sand it down and spray it with something marine grade. What can I do?
- Afrayedknot
- Pro Angler
- Posts: 1913
- Joined: Thu Jun 27, 2013 4:32 am
-
- Pro Angler
- Posts: 1953
- Joined: Fri Jul 05, 2013 7:59 am
- Location: Pensacola, FL
Re: Minkotta Max 80- RUST issues
Funny you found that on the local forum. Some decent advice on there sometimes. No where close to this forum though.
I'd sand it down and use some rustproofing paint, has worked pretty good on some things I've used it for so far.
I'd sand it down and use some rustproofing paint, has worked pretty good on some things I've used it for so far.
-
- Platinum Angler
- Posts: 812
- Joined: Sun Jan 15, 2012 6:08 am
- Location: Denver, CO
Re: Minkotta Max 80- RUST issues
The part that scares me is that it is near that joint. There is some sort of sealant there and I don't want to do any harm.
I guess I may try to tape it off first and see what happens. I wish I had not waited as long as I did.
I guess I may try to tape it off first and see what happens. I wish I had not waited as long as I did.
Re: Minkotta Max 80- RUST issues
I had a MinnKota Fortrex 80 that rusted in the exact same spot and looked the same as yours. I don't know what you can do except follow JB's advice.
Re: Minkotta Max 80- RUST issues
Sand it put some Naval Jelly on it made by loctite (I am pretty sure) then a good oil based rust control paint. ie ruetoleum. And I have 27 years in the paint business FYI.