![Shame on you [-X](./images/smilies/eusa_naughty.gif)
To start with you need to fabricate a .2 to .3 MM thick, 9 mm ID, 12 to 13 mm OD replacement washer/spacer to replace the drive shaft washer. If you use the stock washer the drag stack will hit the handle side plate/cover. The washer must me 9mm plus or it will not fit over the shoulder on the drive shaft.
Daiwa parts (Sol and TD-Z parts) 1-800-736-4653 ext 8
Line guide G01-0401 $21.20 1ea
Drag
Eared washer F79-6101 $0.80 (pixy has 1 you need 2) 1ea
Key washer F79-6301 $0.80 1ea
Key washer B36-0303 $0.85 1ea
Worm drive
Ball bearing (part 39) F05-5601 $8.00 give or take.
Worm shaft Collar G01-0701 $3.00 give or take (Daiwa has them in stock know)
Smooth Drag 1-888-206-4656
Daiwa carbontex #1 $8.00
Ceramic spool bearings. (I use Boca 1-800-332-3256)
$20 to $35 a set, depending on what brand you use.
I would replace the stock handle with TD-Z F83-7201 $40.00, or with any custom handle on the market.
All pricing above does not include shipping and frustation.
![Brick wall ](*,)](./images/smilies/eusa_wall.gif)
All the pricing I mentioned is if you are going to do the job. Pricing of reel repair and tuning shops will vary.
![big grin :big grin:](./images/smilies/ym1.jpg)
You folks have a good week with out me. I am leaving for the mountains .
My thanks to Chucke and Ctanno for the time they put in to allow tinker nuts like me to play with their ideas and their work. (Thank you Gentalmen)
D.R.